Good morning everyone! It’s my second post of the day, but boy is it a fun one! Welcome to the best stamping month of the year. Yes, it’s the 1st September which means it is STAMPtember, a month long party run by Simon Says Stamp celebrating all things stamping…. and much much more!
This post contains affiliate links to some products. Please see my Disclosure And Copyright Page.

Today, Simon Says Stamp are kicking off the fun with a new release. And I have a card to share with you using the beautiful Etched Eucalyptus Wreath die – so so pretty. And I went a little out of my comfort zone and did some pretty muted colours. When I think of eucalyptus I think of greys and greens, so that formed the basis for my card today.

I began by die cutting the eucalyptus wreath twice out of Neenah 110lb cardstock and setting them to one side. Next I took the SSS You Matter background stamp and stamped it onto some SSS Fog cardstock using SSS Fog ink, to give a tone on tone look. It’s very subtle but just enough to add interest behind the wreaths without overpowering them. This panel was cut using a SSS Stitched Rectangle and adhered flat onto a Neenah 80lb panel (which I had trimmed slightly smaller than an A2 card base).

I added some foam tape behind each of the eucalyptus leaves and placed them down onto the white/fog panel, so that they overlapped. I had to remove some of the foam tape pieces behind the overlapping leaves so that it wasn’t too bulky and sat more or less flat on those areas – this was tricky! What I should have done is adhered the overlapping bits with wet adhesive first, and then added the foam tape on the bits that didn’t overlap. But of course, hindsight is a wonderful thing!
I then took the SSS You die and cut it three times from green cardstock. I apologise that I don’t have the name of the cardstock – it was from SSS but they don’t seem to stock it anymore. I will link to something similar below that would work just as well. I added tiny bits of Multi Medium Matte and foam tape to the back of each of the “You” die cuts and adhered it down. As it straddles the wreath, I needed foam tape for some parts so they didn’t sag. Agan, fiddly. This is NOT a card for mass production ha ha.

Next I took a sentiment from SSS You Matter, stamped it onto SSS Smoke cardstock using Versamark ink and applied Ranger Liquid Platinum embossing powder before heat setting. I thought white embossing powder might not be very visible on Smoke cardstock and gold was maybe a bit too harsh. I think Liquid Platinum goes well with the muted greens and greys. I trimmed the sentiment down and adhered it with foam tape and wet adhesive.

To finish the card I added a selection of Raindrops from Lucy’s Cards for embellishment, and then added the whole panel onto a green base card. It’s quite an unusual card for me, particularly with so many layers and the colours but I really liked how it turned out. I will be back with another card for you tomorrow, using the same wreath, but very different to what you see today! I hope you enjoy looking at the STAMPtember new release and thank you as always for joining me today. Happy crafting!
Supplies
In case you feel like doing a little shopping, I have listed the products I have used below. Some of them are affiliate links which means that I receive a small commission if you use one. This is at no extra cost to you and I very much appreciate your support of my crafting adventures. Thank you! To shop at your favourite store, click on your chosen logo.
Lisa this is so beautiful! I can imagine it in so many different colours, but the design and layout is so you and such a classic! I love it!
Fantastic card. Love the new release.
This is so pretty, Lisa! I love the muted colours and the combo works perfectly with the die. Love the design xx