Hello there, today’s card uses the October 2024 BetterPress Plate of the Month which creates a plaid pattern. This is a great kit as it gives you four plates to create your plaid along with a plate of Christmas sentiments. All you need to decide is what colours you want to use and how far to build up the plaid. I paired my background with the penguins from the Large Die of the Month kit for October.

This post contains affiliate links to some products. Please see my Disclosure And Copyright Page.
The BetterPress Plate of the Month Membership for October is called Design-A-Plaid. You get four plates and a registration template which you use to line them up. There are two long plates and two shorter plates. As I mentioned previously, there is also a plate of sentiments that come with a coordinating die.
Main Supplies Used On This Card
- Spellbinders BetterPress Plate of the Month Membership October 2024
- Spellbinders Large Die of the Month Club October 2024
- Spellbinders Taffy, Azalea and Tuscan BetterPress Inks
- Spellbinders BetterPress Letterpress System
- Spellbinders Platinum 6 Die Cutting Machine

To create the background, pop the registration grid onto your BetterPress Letterpress System magnetic platform and tape a panel of Porcelain cardstock to the platen (clear lid). Place the two longest plates onto the grid where indicated and ink them up. I used Taffy and Tuscan BetterPress Inks. Once you have pressed them, flip the platen, reink the plates and then press them again. This will give you the same lines on each side of your panel.
Remove those plates and then put the two smaller plates down onto the grid. I inked these up with Azalea and Tuscan BetterPress Inks. Run it through your die cutting machine and then flip the platen, reink the two plates and press once again. You can change up how many lines etc you want. I went for a full panel.

I die cut a circle section out of the bottom right using a die from Everlasting Circle Etched Dies. I then adhered the panel onto a top folding A2 white note card. The penguins are from the Large Die of the Month Club and they were cut from 80lb white card, Onyx, Persimmon, Tuscan and White Glitter cardstock. I adhered them together using wet adhesive and then added some foam tape onto the back of them before popping them into the circle.

To finish the card, I foiled the sentiment plate from the kit onto Onyx card using White Glimmer Hot Foil and the Glimmer Hot Foil System. The sentiments were all cut out in one pass with the coordinating die and my chosen option was added onto the panel with foam tape.
That finishes my card. I think in hindsight I would have preferred to have the penguins in a full circle towards the top of the card, but it does make the card a little bit different (for me) having them as they are. I hope that you have a great day and thanks for your visit here on my blog today.
Supplies
In case you feel like doing a little shopping, I have listed the products I have used below. Some of them are affiliate links which means that I receive a small commission if you use one. This is at no extra cost to you and I very much appreciate your support of my crafting adventures. Thank you! To shop at your favourite store, click on your chosen logo.
Love it – the colours are a nice change to the usual red and green for Christmas 🙂 Still thinking about this for Christmas. You know I love a good toy!!
aw, so sweet, and I love your plaid colors